|
|
|
|
| Belts, Hoses, Water Pumps & Radiators |
|
|
HomeBelts, Hoses, Water Pumps & RadiatorsO2 SENSOR |
|
|  | | | Customer Reviews: | | | Average Customer Review:
Write an online review and share your thoughts with other customers.
2004 Honda CRV O2 Sensor Sep 01, 2010
After reading some comments in some of the Honda forums, I was concerned that the Denso O2 Sensor would not work or be easy to install. Both were not the case. It was easy to install and it worked fine. The removal was easy, I applied several drops of Liquid wrench, and then used a 7/8" sensor socket (I got mine at Harbor Freight) and it came right out. I slit the rubber bushing off the old sensor and installed it on the Denso, used the anti Sieze compound that came with the sensor and was done in 10 Minutes. I reset the Engine Check light and all is good.
Denso 234-9005 O2 Sensor (2004 Honda CR-V) Aug 31, 2010
The part arrived within 24 hours of ordering it (Amazon), what service! Got a 22mm O2 sensor socket for $6 at the local parts store and had the bad sensor out in about 3 minutes. I verified that the parts looked the same and installed and tested the new Denso sensor in about 2 minutes. Fit perfectly and I saved a bundle on this DIY repair!
Works well. Aug 13, 2010
Installed product. All the comments are accurate. You can do this yourself and save lots of money. The Honda dealer wanted $351 just for the part.
It took some effort to get the old sensor loose and free but other than that you can do it.
The tricky part was getting the connector apart.
The top of the connector has a clip that mounts to the bracket. If you squeeze the top of the clip it will slide off the bracket. In my case I did not need to remove the bracket. Once you do this you can get a better grip on the connector and it will disconnect pretty easily.
It took about 50 miles of driving before the CEL reset.
Perfect replacement for RSX-S Upstream Sensor Aug 09, 2010
This product is a perfect replacement for an Acura RSX-S upstream Air/Fuel (sometime called Oxygen Sensor). Note that the upstream (Pre cat) and downstream (Mid/post cat) sensors are different and this will only work to replace the UPSTREAM sensor. Connector fitted perfectly and cabling was the correct length.
It Works Aug 02, 2010
Purchased this to replace the original in my 2004 CRV. Exact replacement for 1/3 the price.
|
| | |
|
* Estimated shipping rate for US 48 states. Final rate calculated at checkout. |
|
|
|
Atmosphere Solutions