|
|
|
|
|
|
HomeChassis PartsBALL JOINT |
|
|  | | | Customer Reviews: | | | Average Customer Review: ( 7 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
3 of 3 found the following review helpful:
 Watch that grease fitting! Dec 23, 2010
By J. Becnel
"Machine Driver"
Watch out! If you're installing this on a 4X4, don't do what I did - I installed it with the grease fitting in place and realized it way too late - it interferes with the axle U-joint hub and I had a 50-50 chance it would be in the right place to allow me to remove it. I was in the wrong 50%. Bummer so at least I greased it but I had to shear it off and seal the hole with RTV. So happens that item 14 int he little instruction sheet that came with it warns you about this problem but that clue is nowhere else to be found and I wish I had caught it sooner so I'll be doing this job again in a year or 2 since I cannot grease this joint again.
1 of 1 found the following review helpful:
 Worked for me! Mar 11, 2011
By D. Kemp
"AdventureDevon"
I ordered this to replace the upper ball joints on my 2000 Ford F250 4x4, Diesel. Fit was perfect. Just remember to file down the zerk fittings *before* putting it all together (if you want to leave the fittings in there full time) so that the universal joint doesn't whack it when you shift to 4-wheel drive.
moog ball joint Dec 29, 2011
By Jman72
Came quick from UPS. Ordered two of these and two uppers for my F350. They're good quality Moogs, no worries there. Only thing is, make sure you grease the lower ball joints then remove the zerq and install the plug before you put the steering knuckle back on the axle shaft. The zerq does not clear the u-joints. Also, make sure you put the rubber boots on as stated (on the boot), otherwise they will not hold grease properly. I threw the zerqs in a tylenol bottle and put them in the glove compartment. I grease the front end every oil change (5,000 miles for my diesel). It's easiest to get to the plug/zerq for example: drivers side turn tire all the way the right. The plug is some odd size, neither metric or standard, easiest to get on and off with a small crescent wrench. Best thing of all about these ball joints is the price. Way cheaper than from any three of the local auto parts stores. Saved 150 dollars just on ball joints.
Ball joints Nov 25, 2011
By leann greenwell
It Is what I needed. It arrived on time and the packaging was good. Everything was as listed. Would buy again from them.
Perfect for 2002 Ford F350 Nov 06, 2011
By J. Hannigan
This upper ball joint was perfect for my 2002 Ford F350. I had never replaced the joints before and after researching, got all the parts from Amazon and did the job for way less than a shop would charge. The Moog Ball joint was the most recommended and in my experience was the right part for the job.
See all 7 customer reviews on Amazon.com
|
| | |
|
|
|
|
|
Atmosphere Solutions